Adlink HSL-DO32-M-N/HSL-DO32-M-P Uživatelský manuál stáhnout pdf (Strana 38)

Introducing HSL 25

1.4.6 I/O refreshing rate of an HSL system

The scan time unit for one slave index is set in 3/6/12 Mbps trans-

mission rate. Once the maximum slave address is set, the polling

cycle time of the HSL system is using the following formula:

Polling cycle time = maximum-address-of-slave * scan time unit

Table 1-5: Polling cycle time of HSL (Full Duplex Mode)

Note: Regardless of the transmission rate you select, the minimum

polling cycle time is 3×scan time unit, even when the maxi-

mum address is less than 3. Refer to Appendix A.

Maximum

address

Cycle Time

under 3 Mbps

Cycle Time

under 6 Mbps

Cycle Time

under 12 Mbps

5 303.33 µs 151.67 µs 75.83 µs

10 606.67µs 303.33 µs 151.67 µs

20 1.213 ms 606.67 µs 303.33 µs

30 1.820 ms 910.00 µs 455.00 µs

40 2.427 ms 1.213 ms 606.67 µs

50 3.033 ms 1.516 ms 758.33 µs

60 3.640 ms 1.820 ms 910.00 µs

63 3.822 ms 1.911 ms 955.50 µs

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 136 137

Žádné komentáře

Adlink HSL-DO32-M-N/HSL-DO32-M-P Uživatelský manuál Strana 38